Avoid Breaking Your Ultralight Fishing Rod


If you have been ultralight fishing for any length of time you have most likely broken a rod, or two. In order to make sure it doesn’t happen again, there are a few tips that you will wish to think of in order to appropriately preserve the rods, and keep yourself out of scenarios where it might be a possibility.

Protect The Rod Tip

One of the most significant reasons a lot of my ultralight rods have broken is because of faulty care when I’m transferring or saving the rods. Since of the smaller sized, delicate nature of the rod blanks, it is a lot easier to create devastating nicks and dents in the graphite or fiberglass, which will cause them to fail later. Banging the rods versus the automobile door, rocks on the ground, or allowing the rod to fall and hit the flooring a lot of times will cause stress that might result in it snapping on you when you least expect it.

Keep Your Ferrules Tightened

Another huge problem with multi-section ultralight fishing pole is that the ferrules will break if they are not kept tight. While you are on the water, you will wish to periodically examine the fit of the ferrules and make certain that they are tight. If they are loose, and you are lucky, the rod areas will simply separate. Nevertheless, if you are not so fortunate the ferrule will really break from the included stress of casting.

Do Not Cast Heavy Lures

Ultralight fishing rods are smaller sized for a reason: they cast ultralight lures far better. This suggests that you are going to need to pay close attention to the numbers printed on the side of your UL rod. The producer has suggested lure weights that their rod is capable of casting. If you plan to go heavier than these weights, you can normally expect your rod to snap after an energetic casting stroke. The tips on ultralight rods are not constructed to handle much heavier lures, so adhere to the sizes that the maker states they are constructed to deal with.

Do Not Overpower The Hookset

While it is simple to get excited when you hook up with a fish, you are going to want to avoid using sharp, and abrupt hooksets. These hooksets apply large quantities of stress to the rod and, if the fiberglass or graphite remains in a weakened state due to an absence of appropriate care, the rod will snap in two pieces. Rather, you want to make sure that you are using a sweeping motion to the side to set the hook into the fish’s mouth.

No Comments

Leave a Reply

Your email address will not be published. Required fields are marked *